See more projects using this product.
Learn more about Americana Decor® Matte Metallics™.
SUPPLIES
Americana Decor® Matte Metallics™
- Charcoal (ADMMT06)
- Warm Copper (ADMMT15)
Other supplies
- rubbing alcohol
- sandpaper (fine to medium grit)
- 1" painter's tape
- drop cloth (to protect floor)
- side table (with punched metal base)
- 2" angle brush
- damp cloth
- rags (lint-free)
- gloves (disposable )
- foam sponge
- 1 1/2" angle brush
INSTRUCTIONS
NOTES: No primer or sealer is needed before painting or to protect the finish afterwards. Shake the Matte Metallic containers well before using the paint. Let dry completely between painting steps.
- Pour rubbing alcohol on a lint-free cloth and wipe away any dust and factory oils from the side table before painting.
- Lightly sand all surfaces to be painted. Use a damp cloth to clean off all sanding dust.
- Load the tip of a 2" paintbrush with Charcoal and, using long, continuous strokes, in the same direction, paint the bottom section of the side table. (To pant the inside of the punched metal case, use a foam brush. ) Allow 2-3 hours drying time and lightly sand between coats. Wipe with a damp cloth to remove sanding dust.
- Before starting the top, protect the Charcoal painted area by taping it off with painter's tape.
- Load the tip of the 1 1/2" paintbrush with Warm Copper and, using long, continuous strokes in the same direction, paint the top of the side table. Allow 2-3 hours dry time and finely sand between coats. Wipe with a damp cloth to remove sanding dust. (I used three light coats.)
- Remove the painter's tape and allow to dry completely.
; "Pin this on Pinterest")
