Newsletter Instagram YouTube Twitter Pinterest Facebook
DecoArt Mixed Media Blog

"Love Has Wings"

by: Lindsay Mason
June 25, 2015

"Love Has Wings" mixed media wall hanging.

Items needed :

  • DecoArt Media Fluid Acrylics - Cobalt Teal Hue
  • DecoArt Media Fluid Acrylics - Yellow Oxide
  • DecoArt Media Fluid Acrylics - Raw Sienna
  • DecoArt Media Fluid Acrylics - Transparent Red Iron Oxide
  • DecoArt Media Fluid Acrylics - Burnt Umber
  • DecoArt Media Fluid Acrylics - Cobalt Turquoise Hue
  • DecoArt Media Fluid Acrylics - Carbon Black
  • DecoArt Media Antiquing Creams - Patina Green
  • DecoArt Media Mediums and Specialty Products - Gesso - White
  • DecoArt Media Mediums and Specialty Products - Clear Matte Medium
  • DecoArt Media Varnishes - Ultra-Matte Varnish
  • DecoArt Media Mediums and Specialty Products - Crackle Paste - White
  • Americana Decou-Page (Glue-Sealer-Finish) 8oz - Americana Decou-Page Gloss
  • Metallic Lustre 1oz - Copper Kettle
  • Metallic Lustre 1oz - Gold Rush
  • Metallic Lustre 1oz - Brilliant Turquoise
  • Thick Corrugated Card
  • Metal Embellishments
  • Pair of Chipboard Wings
  • Wooden or Chipboard Heart
  • Chipboard Letters
  • Book Paper
  • Aluminum Foil
  • Small Length of Ribbon
  • Brushes
  • Palette Knife
  • Water Spritzer

Instructions :

Cut two rectangles of thick corrugated card approximately 3" x 4" and cut a window out of one of them.

Glue a piece of book paper to the solid rectangle - I chose a dictionary definition of the word "Fly".

Make a glaze by adding a drop of Cobalt Teal Hue to a little Ultra Matte Varnish and brush this over the book paper. Repeat with a glaze of Yellow Oxide.

Crumple up more book paper, flatten out and glue to one side of the cut out rectangle. Cut a cross into the paper behind the window and fold the edges back over the card, sticking into place.

Turn over and paint the inner edges and top surface with Raw Sienna. When dry, go over with a little Transparent Red Iron Oxide and then with even less of Burnt Umber. Allow to dry.

Turn the "frame" over and glue the solid rectangle to the unpainted side (so the text shows through the window). Fold and glue the rest of the book paper around the solid rectangle before painting as in previous step.

 Take a 3" wide piece of corrugated card and cut a half circle at one end.

Scrunch a thin sausage of aluminum foil and glue to the curve, being sure to stop half an inch from the bottom edge as shown. 

Cover with scrunched book paper and paint as in previous step to match the frame. This will be the pediment.

Paint the wings on both sides with Gesso, being sure to leave plenty of brush marks in the surface. Allow to dry.

Paint one side of a wing with Cobalt Turquoise Hue, spritz with a little water and remove some of the paint with a soft cloth. Repeat on each side of both wings.

Using your finger, gently rub Gold Rush Metallic Lustre over the wings, followed by Copper Kettle in some areas. You are only aiming to pick up the textural details so don't rub very hard.

Add the Brilliant Turquoise Metallic Lustre over the frame and pediment.

Glue the wings to the lower edge of the pediment and glue the frame on top to trap them between the two. Keep pressed down,  or place a weight on top, until the glue is set.

Cut a 2" x 3" piece of corrugated card and cover with book paper, painting as before to match the frame. Glue a loop of ribbon to the back of it and stick to the back of the frame below the pediment to act as a hanger.

Paint the small heart with Cobalt Turquoise Hue, allow to dry and paint with a coat of Matte Medium.

Use a palette knife to add a thickish layer of Crackle Paste over the heart. Allow to dry naturally - if placed in a warm, sunny room it will take less time for crackles to appear.

Meanwhile, paint the chipboard letters with Carbon Black - the more roughly the better. Once dry, rub over with the variously coloured Metallic Lustres. Glue to the inside back of the frame.

Paint a key with Burnt Umber and a crown and small heart with Cobalt Turquoise Hue, giving each two layers. Once dry, rub over with Gold Rush Metallic Lustre.

Glue the crown to the back of the top of the pediment, adding painted book paper strips for extra strength. Glue the tiny heart to the inside of the pediment.

Add dictionary words to the wings and frame as shown. Make glazes as in step 3 and paint over the words to blend them into the surface.

Once fully crackled, paint the heart with the Patina Green Antiquing Cream before removing some of the colour with a soft cloth. Apply a coat of Ultra Matte Varnish.

Glue the key to the centre of the heart and rub Gold Rush Metallic Lustre around the edges of the heart before gluing to the bottom edge of the frame to complete the project. Allow everything to fully set before hanging.

Be sure to visit Lindsay Mason for more projects and to learn more about Lindsay Mason.

Comments

What a brilliant project and the step by step photos and instructions are very clear. Makes we want to have a go myself!

Christina Doré

June 25, 2015

This is a very neat project! Love the finished results. The tutorial is wonderful.

Candy Colwell

June 25, 2015

This is a fabulous project Lindsay, love the gorgeous colours!

Anne R

June 30, 2015

Fantastic Lindsay. Love the surface you created and palette you used.

Seth

July 15, 2015

This is such a stunning and inspirational piece, Lindsay! I especially love the selfmade pediment and of course all the yummy textures you have created! Makes me want to create a shrine too! xxx

Claudia

July 17, 2015

I just found this under the assemblage challenge on Paperartsy. It is incredible. I am happy to see how you made all these pieces. Wonderful project.

Lucy

May 10, 2017

Leave a comment:

SUBMIT COMMENT